J Adv Prosthodont.  2022 Aug;14(4):262-272. 10.4047/jap.2022.14.4.262.

Effect of surface treatment on shear bond strength of relining material and 3D-printed denture base

• Park SJ
• Lee JS

• KMID: 2532753
• DOI: http://doi.org/10.4047/jap.2022.14.4.262

Abstract

PURPOSE
. This study aimed to analyze the shear bond strength between the 3D-printed denture base and the chairside relining material, according to the surface treatment.
MATERIALS AND METHODS
. Cylindrical specimens were prepared using DENTCA Denture Base II. The experimental groups were divided into 6 (n = 10): no surface treatment (C), Tokuyama Rebase II Normal adhesive (A), sandblasting (P), sandblasting and adhesive (PA), sandblasting and silane (PS), and the Rocatec system (PPS). After bonding the chairside relining material to the center of the specimens in a cylindrical shape, they were stored in distilled water for 24 hours. Shear bond strength was measured using a universal testing machine, and failure mode was analyzed with a scanning electron microscope. Shear bond strength values were analyzed using one-way analysis of variance, and Tukey’s honest significant difference test was used for post-hoc analysis (P < .05).
RESULTS
. Group PPS exhibited significantly higher shear bond strength than all other groups. Groups P and PA displayed significantly higher bond strengths than the control group. There were no significant differences between groups PS and A compared to the control group. Regarding the failure mode, adhesive failure occurred primarily in groups C and A, and mixed failure mainly in groups P, PA, PS, and PPS.
CONCLUSION
. The shear bond strength between the 3D-printed denture base and the chairside relining material exhibited significant differences according to the surface treatment methods. It is believed that excellent adhesive strength will be obtained when the Rocatec system is applied to 3D-printed dentures in clinical practice.

Keyword

3D printing; Surface treatment; Computer-aided design; Denture base; Rocatec system