J Korean Acad Prosthodont.  1999 Oct;37(5):620-639.

A STUDY ON THE BOND STRENGTH OF REINFORCED INDIRECT COMPOSITE RESINS TO DENTAL ALLOYS

• Yoon DJ
• Shin SW
• Suh YW
• Lim HN

Abstract

Indirect composite resin are used as an popular effective esthetic material in prosthetic dentistry, often with metallic substructure that provides support for restorations. Recently, new indirect composite resins as a substitute of ceramic have been developed. These resins provide good esthetics, with a wide range of hue and chroma. And the flexural strength of those is in the range of 120-150MPa, which is higher than that of feldspathic ceramic, and similar tot hat of Dicor. Although it has many merits, one of the major clinical problems of composite resins is the bond failure between metal and resin due to insufficient interfacial bond strength. The purpose of this study was to evaluate shear bond strength of the reinforced indirect composite resin to dental alloys. Three different composite resin systems(Artglass . Sculpture , Targis ) as test groups and ceramic(VMK 68 ) as control group were bonded to Ni-Cr-Be alloy(Rexillium III ) and gold alloy(Dave 4). All specimens were stored at 37degrees C distilled water for 24 hours and the half of specimens were thermocycled 2000 times at temperature from 5degrees C to 60degrees C. The shear bond strengths of reinforced indirect composite resins to dental alloys were measured by using the universal testing machine, and modes of debonding were observed by stereoscope and scanning electron microscope. The results were as follows : 1. The shear bond strengths of reinforced indirect composit resins to dental alloys were approximately half those of ceramic to dental alloys(P<0.01). 2. There was no significant difference between the shear bond strength of several reinforced indirect composite resins to metal. 3. Alloy type did not affect on the shear bond strengths of resin to metal, but the shear bond strengths of ceramic to gold alloys were higher than those of ceramic to Ni-Cr alloys(P<0.05). 4. The shear bond strenghts of Artglass and Targis to gold alloys were significantly decreased after thermocycling treatment(P<0.01). 5. Sculpture showed cohesive, adhesive, and mixed failure modes, but Artglass and Targis showed adhesive or mixed failures. And ceramic showed cohesive and mixed failures.

MeSH Terms

Adhesives
Alloys
Ceramics
Composite Resins*
Dental Alloys*
Dentistry
Esthetics
Gold Alloys
Sculpture
Water
Adhesives
Alloys
Ceramics
Composite Resins
Dental Alloys
Gold Alloys
Water