J Adv Prosthodont.  2023 Jun;15(3):145-154. 10.4047/jap.2023.15.3.145.

Effect of internal structures on the accuracy of 3D printed full-arch dentition preparation models in different printing systems

• Ma T
• Peng T
• Lin Y
• Zhang M
• Ren G

• KMID: 2544056
• DOI: http://doi.org/10.4047/jap.2023.15.3.145

Abstract

PURPOSE
. The objective of this study was to investigate how internal structures influence the overall and marginal accuracy of full arch preparations fabricated through additive manufacturing in different printing systems.
MATERIALS AND METHODS
. A full-arch preparation digital model was set up with three internal designs, including solid, hollow, and grid. These were printed using three different resin printers with nine models in each group. After scanning, each data was imported into the 3D data processing software together with the master cast, aligned and trimmed, and then put into the 3D data analysis software again to compare the overall and marginal deviation whose results are expressed using root mean square values and color maps. To evaluate the trueness of the resin model, the test data and reference data were compared, and the precision was evaluated by comparing the test data sets. Color maps were observed for qualitative analysis. Data were statistically analyzed by one-way analysis of variance and Bonferroni method was used for post hoc comparison (α = .05).
RESULTS
. The influence of different internal structures on the accuracy of 3D printed resin models varied significantly (P < .05). Solid and grid models showed better accuracy, while the hollow model exhibited poor accuracy. The color maps show that the resin models have a tendency to shrink inwards.
CONCLUSION
. The internal structure design influences the accuracy of the 3D printing model, and the effect varies in different printing systems. Irrespective of the kind of printing system, the printing accuracy of hollow model was observed to be worse than those of solid and grid models. [J Adv Prosthodont 2023;15:145-54]

Keyword

Additive manufacturing; Trueness; Precision; 3D-deviation; Color map