J Adv Prosthodont.  2020 Dec;12(6):351-360. 10.4047/jap.2020.12.6.351.

Effects of overdenture attachment systems with different working principles on stress transmission: A three-dimensional finite element study

• Turker N
• Buyukkaplan US

• KMID: 2509773
• DOI: http://doi.org/10.4047/jap.2020.12.6.351

Abstract

PURPOSE
The aim of the present study was to compare the stress distributions on the dental implants, abutments, and bone caused by different overdenture attachment types under functional chewing forces.
MATERIALS AND METHODS
The 3D finite element models of the mandible, dental implants, attachment types, and prostheses were prepared. In accordance with a conventional dental implant supported overdenture design, the dental implants were positioned at the bone level in the canine teeth region bilaterally. A total of eight models using eight different attachment systems were used in this study. All the models were loaded to simulate chewing forces generated during the centric relationship (450 N), lateral movement (400 N), protrusive movement (400 N), and also in the presence of a food mass unilaterally (200 N). Stress outputs were obtained as the maximum principal stress and the equivalent von-Mises stress.
RESULTS
In all attachment types, higher stress values were observed in the abutments, dental implants, and bone in the magnet attachments in different loading conditions. The highest stress values were observed among the magnet systems in the components of the Titanmagnetics model in all loading conditions (stresses were 15.4, 17.7, and 33.1 MPa on abutment, dental implant, and bone, respectively). The lowest stress value was observed in the models of Zest and O-Ring attachments.
CONCLUSION
The results of the present study implied that attachment types permitting rotation and tolerating various angles created lower stresses on the bone, dental implants, and abutments.

Keyword

Dental implants; Mandible; Finite element analysis; Occlusion