- The physical properties of reused IPS empress ceramic part IV: Hardness and fracture toughness
-
Jin TH
- KMID: 900155
- J Korean Acad Prosthodont.
- 2003 Aug;41(4):532-537.
STATEMENT OF THE PROBLEM: IPS Empress ceramic has been used as one of a esthetic restorative material since it's development, but the broad application of IPS Empress ceramic to clinical... -
- CITED
-
- Close
- SHARE
-
- Close
- Effect of hema and tegdma on the properties of experimental composite resins
-
Han MH
- KMID: 900151
- J Korean Acad Prosthodont.
- 2003 Aug;41(4):476-492.
PURPOSE: The purpose of this study was to compare HEMA and TEGDMA as diluents for the composite resin. MATERIAL AND METHODS: Eight kinds of experimental light curable composite resins were... -
- CITED
-
- Close
- SHARE
-
- Close
- Mechanical properties of laser welded Co-Cr alloy
-
Bae KC, Woo YH, Lee SB
- KMID: 900148
- J Korean Acad Prosthodont.
- 2003 Aug;41(4):440-450.
STATEMENT OF PROBLEM: The joints of removable partial denture alloys have failed frequently after routine usage. PURPOSE: The purpose of this study was to evaluate the mechanical properties of the... -
- CITED
-
- Close
- SHARE
-
- Close
- A study of screw loosening after dynamic continous fatigue test of several abutment screw
-
Kim JM, Han JS, Lee SH, Yang JH, Lee JB, Kim YS
- KMID: 900154
- J Korean Acad Prosthodont.
- 2003 Aug;41(4):519-531.
STATEMENT OF PROBLEM: Chronic implant screw loosening remains a problem in restorative practices. Some implant manufactureres have introduced abutment screws with treated material, surfaces and macrostructures in an effort to... -
- CITED
-
- Close
- SHARE
-
- Close
- Influence of implant-abutment interface design, implant diameter and prosthetic table width on strength of implant-abutment interface: three-dimensional finite element analysis
-
Oh SW, Yang JH, Lee SH, Han JS
- KMID: 900145
- J Korean Acad Prosthodont.
- 2003 Aug;41(4):393-404.
STATEMENT OF PROBLEM: Higher incidence of prosthetic complications such as screw loosening, screw fracture has been reported for posterior single tooth implant. So, there is ongoing research regarding stability of... -
- CITED
-
- Close
- SHARE
-
- Close
- Effects of various cements and thermocycling on retentive strengths of cemented implant-supported prostheses
-
Cho JH, Jeong CM, Jeon YC
- KMID: 900150
- J Korean Acad Prosthodont.
- 2003 Aug;41(4):466-475.
STATEMENT OF PROBLEM: In cemented implant-supported porstheses, it is still controversy what kind of cement to use. However, the effect of thermocycling on retentive strength of cemented implantsupported prostheses has... -
- CITED
-
- Close
- SHARE
-
- Close
- The fracture resistance and stress distribution of all ceramic crowns with two types of finish line on maxillary central incisor
-
Ki TS, Kim KS, Lee JH, Kim YL, Dong JK
- KMID: 900146
- J Korean Acad Prosthodont.
- 2003 Aug;41(4):405-420.
PURPOSE: The purpose of this sudy was to compare the fracture resistance of the IPS Empress ceramic crown with 1.0mm width rounded shoulder, which is usually recommended in all ceramic... -
- CITED
-
- Close
- SHARE
-
- Close
- Computer-aided casting design for implant titanium superstructures
-
Oh SW, Lee HY, Lee KW, Shim JS
- KMID: 900147
- J Korean Acad Prosthodont.
- 2003 Aug;41(4):421-439.
STATEMENT OF PROBLEM: It is difficult to obtain a good titanium casting body using the traditional sprue design because of high melting point of Ti, and the low fluidity and... -
- CITED
-
- Close
- SHARE
-
- Close
- A study on the fit of the implant-abutment-screw interface
-
Kim NH, Chung CH, Son MK, Back DH
- KMID: 900153
- J Korean Acad Prosthodont.
- 2003 Aug;41(4):503-518.
STATEMENT OF PROBLEM: There have been previous studies about considerable variations in machining accuracy and consistency in the implant-abutment-screw interfaces. PURPOSE: The purpose of this study was to evaluate the... -
- CITED
-
- Close
- SHARE
-
- Close
- The effects of fabrication of gold cylinder and abutment on the fitness and preload of the prosthesis
-
Ha JI, Jeong HY, Kim YL, Cho HW
- KMID: 900149
- J Korean Acad Prosthodont.
- 2003 Aug;41(4):451-465.
STATEMENT OF PROBLEM: Recently various implant components such as premachined gold cylinder, plastic cylinder, gold UCLA abutment and plastic abutment were developed and used clinically without clinical investigation. PURPOSE: The... -
- CITED
-
- Close
- SHARE
-
- Close
- The effect of denture cleansers on the bond strength and the surface hardness of reline resin to denture base resin
-
Kim KS, Jeong HY, Kim YL, Cho HW
- KMID: 900152
- J Korean Acad Prosthodont.
- 2003 Aug;41(4):493-502.
STATEMENT OF PROBLEM: Removable partial denture and complete denture often require denture base relines to improve the fittness against tissue-bearing mucosa because of the gradual change in edentulous ridge contour... -
- CITED
-
- Close
- SHARE
-
- Close
