Skip Navigation
Skip to contents
Filter

ARTICLE TYPE

PUBLICATION DATE

13 results
Display

A THREE DEMENTIOAL FINITE ELEMENT ANALYSIS OF THE EFFECT OF SEVEN IMPLANT DESIGNS ON STRESS DISTRIBUTION

Heo SJ, Han CH, Chung JP

  • KMID: 2118585
  • J Korean Acad Prosthodont.
  • 1997 Sep;35(3):609.
INTRODUCTION Stress or strain-induced bone remodeling is an important response in unctional adaptation of bone around implants. The overload on the implants can cause the pathologic bone resorption and results...
CITED
export Copy
Close
SHARE
Twitter Facebook
Close
A THREE DIMENSIONAL PHOTOELASTIC STRESS ANALYSIS OF OMPLANT-SUPPORTED MANDIBULAR OVERDENTURE ACCORDING TO IMPLANT NUMBER AND ATTACHMENT TYPE

Han SH, Tae YS, Jin TH, Cho HW

  • KMID: 2118584
  • J Korean Acad Prosthodont.
  • 1997 Sep;35(3):577-608.
The purpose of this study is to evaluate the stress distribution in the bone around dental implants supporting mandibular overdenture according to the number of implant and the type of...
CITED
export Copy
Close
SHARE
Twitter Facebook
Close
EFFECTOF SOLDERING CONDITION ON THE TENSILE STRENGTH TITANIUM SOLDER JOINT WITH 14K GOLD SOLDER

Choi JH, Kim TJ, Song KY, Park CW

  • KMID: 2118583
  • J Korean Acad Prosthodont.
  • 1997 Sep;35(3):566-576.
This study was performed to evaluate the tensile strength of solder joint in titanium and the wettability of 14K gold solder on titanium. Two pieces of titanium rod 30 mm...
CITED
export Copy
Close
SHARE
Twitter Facebook
Close
BICOMPATIBILITY OF BICOMTALS IN RABBIT BONE

Han CH, Hoe SJ, Chung CP, Ku Y, Rhyu IC, Choi YC

  • KMID: 2118582
  • J Korean Acad Prosthodont.
  • 1997 Sep;35(3):557-565.
Screw-shaped implants of commercially pure (c.p.) titanium, c.p. niobium, c.p. zirconium, and stainless(Sus 304) were inserted in the rabbit tibial over 12 weeks of follow-up. New developed torque gauge instrument...
CITED
export Copy
Close
SHARE
Twitter Facebook
Close
THE CLINICAL STUDY ON SHORT TERM PROGNOSIS OF IN-CERAM ALUMINA BRIDGE RESTORATION

Jo BW, Park JB, Ann JJ

  • KMID: 2118581
  • J Korean Acad Prosthodont.
  • 1997 Sep;35(3):544-556.
All ceramic restorations except In-Ceram Alumina system gave a good esthetics and an exellent marginal fidelity. The flexural strength of them had about 150MPa, so the indication is only single...
CITED
export Copy
Close
SHARE
Twitter Facebook
Close
A STUDY OF IMPRESSION TECHNIQUE USING PUTTY MATERIAL OF PVS IMPRESSION MATERIAL

Jeon YC, Nah KS

  • KMID: 2118580
  • J Korean Acad Prosthodont.
  • 1997 Sep;35(3):535-543.
In order to compare the accuracy of impression technique using the addition silicone putty and improved heavy body material, impression were taken for the natural 6 maxillary anterior teeth, and...
CITED
export Copy
Close
SHARE
Twitter Facebook
Close
THREE DIMENSIONAL FINITE ELEMENT STRESS ANALYSIS OF THE MANDIBULAR CONDYLE DURING UNILATERAL CLENCHING

Nam DH, Hoe SJ, Kim KN

  • KMID: 2118579
  • J Korean Acad Prosthodont.
  • 1997 Sep;35(3):517-534.
It has been held that excessive mechanical forces to the osseous and soft tissues of the TMJ result in joint dysfunction. Understanding the stress pattern on TMJ is very important...
CITED
export Copy
Close
SHARE
Twitter Facebook
Close
STUDY OF THE EFFECT OF ULTRASONIC INSTRUMENTATION ON BOND STRENGTH OF SEVERAL DENTAL CEMENTS

Kim WS, Lim JH, Cho IH

  • KMID: 2118578
  • J Korean Acad Prosthodont.
  • 1997 Sep;35(3):504-516.
Ultrasonic instruments transfer electrical energy to mechanical energy resulting in vibration used for various dental treatments. If we could know the effect of ultrasonic instruments on the dental cements within the...
CITED
export Copy
Close
SHARE
Twitter Facebook
Close
A PHOTOELASTIC ANALYSIS ON TOOTH SUPPORTING STRUCTURE AND RESIDUAL RIDGE ACCORDING TO DENTURE DESIGN FOR REMAINING MANDIBULAR CANINES

Kim IP, Koh JW, Jin TH

  • KMID: 2118577
  • J Korean Acad Prosthodont.
  • 1997 Sep;35(3):486-503.
The purpose of this study was to evaluate the stress patterns developed in abutment and residual ridge according to removable denture design in case of remaining mandibular cannies The removable denture...
CITED
export Copy
Close
SHARE
Twitter Facebook
Close
A STUDY OF THE TENSILE LOAD OF SEVERAL CLASPS ACCORDING TO VARIOUS UNDERCUT AREA

Kim BH, Lim JH, Cho IH

  • KMID: 2118576
  • J Korean Acad Prosthodont.
  • 1997 Sep;35(3):470-485.
A fundamental principle in clasp selection for a specific abutment is the reduction of the transmission of excessive forces to the abutment tooth. Those forces include tilting, tipping, and stress...
CITED
export Copy
Close
SHARE
Twitter Facebook
Close
THE TENSLE BOND STRENGTH AND ELASTIC MODULUS OF THE SOFT DENTURE LINING MATERIALS

Kim BJ, Koh JW, Lee YK, Cho HW

  • KMID: 2118575
  • J Korean Acad Prosthodont.
  • 1997 Sep;35(3):458-469.
This study was to compare the tensile bond strength and flexibility of four different soft liners(Coe Soft, Soft Relining, Soft Liner, Dura Base Soft) before & after thermocycling. Each soft...
CITED
export Copy
Close
SHARE
Twitter Facebook
Close
MARGINAL FIDELITY ACCORDING TO THE MARGIN TYPES OF ALL CERAMIC CROWNS

Koo JY, Lim JH, Cho IH

  • KMID: 2118574
  • J Korean Acad Prosthodont.
  • 1997 Sep;35(3):445-457.
Poor marginal fidelity resulting in a large marginal gap increases plaque accumulation, gingival inflammation and dental caries. The purpose of this study was to evaluate the marginal fit of three different...
CITED
export Copy
Close
SHARE
Twitter Facebook
Close
THE TRANSMANDIBULAR IMPLANT SYSTEM

Moon HS

  • KMID: 2118573
  • J Korean Acad Prosthodont.
  • 1997 Sep;35(3):435-444.
Many of problems which are faced to the edentulous patients are related to a minimal amount of available mandibular bone volume and height. Most of the patients with mild atrophy...
CITED
export Copy
Close
SHARE
Twitter Facebook
Close

Go to Top

Copyright © 2021 by Korean Association of Medical Journal Editors. All rights reserved.     E-mail: koreamed@kamje.or.kr